If you are encountering login problems please check here
Search Results
welcome, and yeah the rust thing happens. I did see a really nice looking TC today in my travels through East Berlin PA. Actually the second one I've seen recently, the other was in New Holland PA. ...
266
I rebuilt the prop valve after a heck of time getting it apart. Actually had to use acetylene torch to get enough heat on it to get it apart. Cleaned the heck out of it and reassembled and installed...
1,514
I pulled the master cylinder and proportioning valve. I took the ends of the prop valve and there was some stuff hardened up in it, didn't pull the plunger out of the master cylinder. I hit one of t...
1,514
The bleeders are drilled on the sides, but it's a reasonable question.
1,514
I got the rear stuff put together. The new pads had some kind of spring clip or something with them, not sure what it was for; at least the old setup didn't have anything like it. The 82/83 caliper ...
1,514
Yeah, seems quite strange that Ford would put them in anything that they were producing with such limited numbers on them.
1,288
Congrats to Fred, glad he finally got it worked out! From what I remember he has the old tall deck block and the chassis was an old prostock Glidden ride. I haven't spoken with him since he retired ...
1,288
I got all of my parts in to replace the front and rear brakes. I started with the fronts, got the driver's side done and went to the passenger side, but the box for the passenger side had a driver's ...
1,514
I got it from RockAuto, the code listed in their post expired October of last year....so, no I did not use the discount code.
1,514
I ordered one of the 82-83 left rear calipers to check it out.  I figured it's cheap enough to check it out, less than $25 with shipping.
1,514
I tried 88 Lincoln Mark VII, which had the same part number but get the same results. They show available until I try to put them in cart. I assume the search features are based on part numbers, reg...
1,514
I'm having trouble sourcing some SVO rear brake calipers.  Everyone says they are no longer available, so I pieced together all of the parts to rebuild them from Rockauto.  Fortunately I don't have an...
1,514
I'm missing the brackets. They were apparently taken off a long time ago and the bolt holes for the brackets have been filled and painted over. I don't think I'll be installing these, unless it need...
546
The side spats were missing when I purchases the car.  I purchased a set of fiberglass ones a long time ago but I have no clue how they mount to the body.  I don't see any brackets or anything.  Does ...
546
Thanks Stinger, after multiple searches online and not being able to find the correct switch I started researching that option.  I think I'll use ALED (pin 16) for fan control and WLED (pin 17) for bo...
510
I've been tinkering on the SVO off and on for the past 6 months, after leaving it sit torn apart for almost 10 years.  I did get it fired up, just to check things out, after installing a MicroSquirt a...
510
I think I found them on the diagram. It appears as though the yellow and brown wires go to the fuel pump relay and the red wire goes to the inertia switch.
566
I started pulling my engine wiring harness tonight.  I got the plug out of the firewall, disconnected the ground wire from the inside.  I was able to pull the harness out some but not all the way.  I ...
566
Yeah, they would work too but if I could get a hold of the stock clamps that's what I would prefer. I sent a PM to you 50RACER.
743
Welcome back and good luck with the build. I recently got back to work on mine too after letting it sit in the garage for years. I knew very little about the car years ago when I stopped working on ...
661