If you are encountering login problems please check here
Search Results
TurboRay Wrote: (11-06-2020, 02:58 AM) -- . "Yes" WHAT, Mike? Yes, your f/system schematic is the same as my preference? If so, then I suspect you've got a poor-performing f/pump, as Mike suggested....
991
TurboRay Wrote: (11-05-2020, 10:32 PM) -- .  It seems unlikely to me that both FPR's would be defective, Mike. Sooo......ASSuming that yer f/pump is putting out its' rated pressure, I tend to wonder...
991
I am having issues with no rise in fuel pressure under boost.  I have a Stinger billet adapter block. I have both a Kirban and an Aeromotive rail type regulator. I have run both of them (neither is...
991
These had only idle time on them. They were sent back to SMP and cleaned, new filters installed and were flow tested.  They are 100% fresh and basically new, since they have been serviced.  Amer...
359
2 gauge Fox body pod with AutoMeter white faced lunar AFR gauge and boost gauge $150.00 "Turbo Fuel Injected" flat top valve cover in crinkle black with -10 port on back. Some scratches from pullin...
431
Do you have some kind of boost target limiter activated? What kind of engine management?
1,395
Stinger Wrote: (04-29-2020, 07:33 PM) -- 3D printing an intake in a material that will hold up to high boost is not a trivial matter either. Even some factory composite intakes have issue with big bo...
3,969
TurboRay Wrote: (04-29-2020, 05:55 PM) -- MikeLTDLX Wrote: (04-29-2020, 01:16 PM) -- (1) I know the good Dr. has been very successful with his blow through setup. However, once I started to play wit...
3,969
TurboRay Wrote: (04-28-2020, 11:53 PM) -- . If there there was ever gonna be an aftermarket EFI intake made for "our" lowly 2.3T Lima engine......I suspect it woulda happened during the production y...
3,969
It still amazes me that, to this day, you have two options for an intake for a Turbo 2.3. Either stock castings, or you fabricate something. Nobody in the almost 40 years this platform has existed...
3,969
Ductape Wrote: (04-21-2020, 07:56 PM) -- If BoPort offers it for the 2.3 I think you’ll be happy with it. -- Probably. Should be ordering it tonight.
952
Ok, then. I guess I will be the virgin sacrifice to the speed gods with this one. Tune in for results.
952
This turbo is one that caught my eye over on Bo-Port's site. It looks like a good upgrade over the SC50 that I currently have, and it is available with the same compressor cover for a reduced footprin...
952
Hey Ductape, I sent you a PM. Did you get it?
3,969
Great info there, Ray. It is too bad the 2.3T market is such a niche that no manufacturer was willing to design a superior aftermarket intake setup. It still blows my mind that our options are ported ...
3,969
Yes, it did have a head gasket issue. However, I don't see how an event that is transpiring further down the chain is going to result in one super clean port, two dirty ports and one pretty clean port...
3,969
Thanks, Billy. In the middle of an engine swap, so I have time. I appreciate your effort!
3,066
I am taking the engine out of my SVO in preparation for a motor swap.  The intakes are ported, but the upper is not gutted and the lower is not knife edged, more of a mid-level of porting.  What...
3,969
Thanks for the offer, I just got one delivered today.
828