If you are encountering login problems please check here
Search Results
Harness: https://www.stinger-performance.com/store/wiring/pimp-wiring/pm-65-pimp-harness-batch-4 Standalone ECU: https://www.stinger-performance.com/store/tuning/pimp-engine-management/pimpx-engine...
119
How it will feel depends as much on the engine combination and vehicle its in as it will depend on the OD and rear axle ratios. A stock cam/small cam combo will take a big final drive ratio much bette...
455
It depends on your thermostat. You don't want the fan coming on before the thermostat opens (or at the same temp). You also want it hot enough to make sure any water (condensation) in the oil will...
155
PintoRoyL Wrote: (06-22-2021, 11:23 PM) -- I am new here, and also new to working on EFI and turbo systems. As I am beginning to read, study, and learn about EFI/Turbo powered engines, I was able to ...
984
Where was the HP peak on the dyno? That alone will tell us a lot. Post the dyno sheet if possible. I agree that the stock upper isn't helping things but it's not costing you 100hp (how much I thin...
1,246
TO4B's in general are "low boost" turbos better for large displacement/low boost setups than our little high boost engines but without knowing exactly which "B" wheel it is, nobody can definitively sa...
694
Good to hear, thanks for the feedback.
454
It can be used as long as you use the pickup for it as well. Don't use the M86CHV under any circumstances.
501
When people do this, I see far more people create issues than those that don't create any issues. Normally the issues are related to the signal return (ground) wires that run to all of the sensors. So...
1,153
teal95 Wrote: (04-06-2021, 01:31 PM) --  The biggest pain will probably be adding all the extra inputs that the L series requires (brakes, speedo...) -- The L series doesn't require any of that to ...
1,938
They are no longer made but there is a stronger option available for the same or less money than the last batch of Crowers: https://www.stinger-performance.com/store/engine/engine-rods/billet-h-beam-...
256
With a 99 you'll need to use a flash programmer like our SCT products and for custom MAF curves and adding boost and such you'd be best off using the Advantage III software so you have full control of...
507
PiMPx is for 95 and older Rangers so it won't work in yours unless you swap in an older harness and convert it to work in your chassis.
2,335
Info from other sources (who talked to Fred about his blocks) says they came from abandoned circle track builds, not tugs.
2,083
Ah, I was assuming tug meant tub boat but I guess that was incorrect. I do know the Lima industrial was used in fork lifts (which appear to be cousins with the tug in the pic above). I'd never heard o...
2,083
Lon Danley Wrote: (02-26-2021, 03:08 AM) -- Don't quote me on it, but I believe Fred bought a bunch of tugs at a government auction, pulled the engines out, and scraped the remains. Netting him plent...
2,083
There are two Turboford FB groups, the "Turboford.org" one is ran by this site, the other one (the larger of the two) is ran by Jackie Flanders.
387
The heater brings the sensor up to operating temperature quickly so it can begin working as soon as possible. Temperature affects resistance and resistance affects current flow, so the sensor must be ...
1,850
Should have messed with it while it was on the dyno. That's a prime time to see what it likes.
1,087