Search Results
I'm another 400+rwhp member of the a-237 club. Not a bad cam and sounds cool at idle.
Whats the 12 degrees of timing? Just base or total?
2,123
It's hard to be a dull crayon when none of them are sharp. Still here on turboford people are about to do it. This isn't just new people as much as just stupid people.
When we have people with a whol...
259
I'm interested in the elbow if dcp passes.
441
As for the mosers you are going to the 31spline right? You can use a ford traction lock from an explorer(31 spline)with extra clutches to make it all tight.
Thats the way I ended up doing mine. The s...
510
Just swap the axles around and in like 30 passes they will be straight again? :)
510
You might need to go with a larger exhaust hosuing on the holset. After alot of reasearch it looks like the 12cm is just to small for big hp. Testing the pressure in the exhuast manifold will tell you...
6,289
Looking good man!
1,542
Yeah and that makes you a moron :)
Side deals and shady **** is beneath most people on here. There are alot of reasons why there should be edicate to deals with fellow members of a community.
1,089
I'd bet the 9cm housing is what limits the turbo before the compressor wheel.
That was case for me with the hx35 with a 12cm housing. Swapped into a 60mm 6 blade high flow wheel and the car didn't pi...
442
Pending to someone other then first poster? Thats pretty gay. If someone pm'd they should be polite enough to post it up!
1,089
I know power2weight had the issue.
He ended up needing new firm ware because the beta he had wasn't quite right. You'd have to ask him for the details as I'd only mess up the full story.
5,587
Definately need the whole slip.
Generally though that kind of et is bad though. Et isn't all about power though it's about traction. Mph is a show of hp. If you went a 9.7 at like 85mph then your doi...
618
The set up looks nice. I never had good luck doing valve cover with the felpro gasket.
337
DVOM = digital volt and ohm meter?
3,490
You could use the ms2 to datalog the voltage?
Or maybe get someone to put a voltmeter on it while you do a wot 4th gear pull?
3,490
Which spec clutch is it?
440
Stinger can you relink that? I'm pulling the old fyi non existent thing.
724
So no one you know of locally has one? I would think with Stinger local as well as 91turboranger you could get a block pretty easy. Isn't brian hall local as well?
1,154
I hate the look of the brass fittings in an engine bay. I've been looking around at some chrome or nickle plated on but only place I found any is ebay and they charge more in shipping and handling the...
279