Had snow here in East Tennessee today so it was a good day to change the Clutch Cable. Real easy with the front seat out. All is well now.

Well I looked in the right place as you all guided - and there it is. I have replaced the DogBone after it failed last week - I have a new 60 inch cable I will replace soon as preventative maintenance...

Thanks for correcting my signature and thanks for the guidance on the clutch cable.

I have seached our files with no results. Does anyone have the procedure to change a Clutch Cable (60 inch) on a 1984 Turbo Mustang? I can't even see the quadrant under the Instrument panel. I'm OK fr...

Where can I get the 2 " cable. Mine just broke and as a quick fix I substituted a 1/4 hex bolt with a locknut. Seems to work fine. While I am at it where can I get a new clutch cable - the aftermarke...

I need a turbo for a 1988 TurboCoupe.

I have been on this Forum for several years. The forum participants have given me several good ideas about Rear Main bearing Leaks and other typical problems. I have replaced the rear main bearing in...

I am going to get a 1986 Crown Victoria MC. I'll go get one at Advance Auto. I will checkout Hawk Pads. Thanks, Richard

Any ideas about how to improve front disk brakes on my 1984 Mustang Turbo4? I have new pads and S/S brake lines all around. I am looking for some ideas short of 1992/3 Cobra brakes. I want to keep th...

Problem solved. Left hand motor mount loose. Tightened bolt - all is well. Motor mount looks bad - now need a replacement. Parts Stores don't have a mount that will work. NEED more help. Thanks!

By the way the clutch is a stock flat disc type.

I have done a search and haven't found anything that talks about a clutch that chatters sometimes. Mine is a 2.3 turbo/4.1 rear axle. Minor rear main bearing leak and a clutch with 4000 miles. Befor...

Just looking thru Ford gears. The OD varies with the ratio - number of ring gear teeth. I would think the Bolt Circle or Ring ID or Pinion Bearing OD would be a good way to identify what is what sinc...

Can anyone tell me how to ID a Ford 7.5 inch Ring and Pinion gear set. I need some id/od, bearing od's measurements to help me tell one from the other with just a measuring tape.

I am away from home for about 2 months and can not get to my car. I am trying to line up some parts to do a gear change when I get home. If it is an Auburn will the same ring and pinion fit as in a F...

Does the stock 1984 GT350 2.3L Turbo have a Limited Slip Rear Axle. Mine feels like it when turning slowly or is something wrong?

fourplay, Yes,just the front. The rear is soft - I have some airlifts on the rear to hold it up when I pull a 4x8 trailer.

Michael Dunn, My Mustang has 205/70-14's at 30 psi.

No mods of any kind on the front suspension. The idea about the sway bar bushings sounds good. Thanks for the input!

Good to have the site up and running again. I did a search and could not find any comments about front suspension stiffness. My Mustang 2.3 Turbo with 28000 miles doesn't take bumps very well. It ap...