If you are encountering login problems please check here

.57 trim wheel in .50 housing?
#1

Is it possible to have .57 trim wheel in .50 housing I bought my t3/t4 with the specs .63ar .57 trim .60 housing but the housing says .50 on the outside. The exhaust side says .63. The turbo does fine except it has some boost creep top end any input would be helpful. I would just like to know what it is so I am not fibbing when I say the specs.
gillis bcv, ported upper/lower, E6, ranger roller, walbro 255, t3/t4, 23psi, LM1, afpr, 46lb inj, npr, ssqv bov, alky inj.
Reply


Messages In This Thread
.57 trim wheel in .50 housing? - by svostang - 06-22-2005, 11:51 PM
RE: .57 trim wheel in .50 housing? - by bhuff - 06-23-2005, 12:39 AM
RE: .57 trim wheel in .50 housing? - by Stinger - 06-23-2005, 12:46 AM
RE: .57 trim wheel in .50 housing? - by svostang - 06-23-2005, 12:49 AM
RE: .57 trim wheel in .50 housing? - by svostang - 06-23-2005, 05:53 AM
RE: .57 trim wheel in .50 housing? - by Stinger - 06-23-2005, 02:34 PM
RE: .57 trim wheel in .50 housing? - by 87Notch - 06-24-2005, 03:05 AM
RE: .57 trim wheel in .50 housing? - by Stinger - 06-24-2005, 02:37 PM
RE: .57 trim wheel in .50 housing? - by Kevin Doe - 06-24-2005, 03:04 PM
RE: .57 trim wheel in .50 housing? - by Stinger - 06-24-2005, 03:50 PM
RE: .57 trim wheel in .50 housing? - by Hemi - 06-24-2005, 11:45 PM
RE: .57 trim wheel in .50 housing? - by Deja-Vu - 06-25-2005, 02:16 AM
RE: .57 trim wheel in .50 housing? - by svostang - 06-25-2005, 02:27 AM



Users browsing this thread: 1 Guest(s)