does anyone still have the dimensions for the block bellhousing end. trying to do some machining on parts and don't have access to a block right now. need locations for bolt and dowel holes please. or a complete blueprint.
Thanks
Mike K
07-21-2022, 09:02 AM
(This post was last modified: 07-21-2022, 07:11 PM by
TurboRay.)
.
The link below will take you to a thread on "turbosport.co.uk"........scroll down to post #7 for a blueprint of the bell-pattern & dimensions of an EAO 2.0 (early Capri/Pinto) engine, which has the exact same rear bolt spacing & pattern as a '74-up 2.3/2.5 Lima. (+ CVH, Zetec, Sierra DOHC, & 2.3/3.5 HSC). YW! <thumbup>
LINK
Placerville, California
(former) '78 2.3T Courier w/blow-thru Autolite 2bbl carb ~ (current) '87 2.3T Ranger w/PiMP’d EFI
need help on another one, anyone have a blueprint or dimensions on the back of a small block ford.
thanks would appreciate it.
Mike K
